Bertos Gold 600 - Reversing the Double Door Opening

ENGLISH Gold/Plus/Easy refrigerated cabinets
62
Ed. 12/2020
– rest the appliance door on it and fit the upper cap (12) onto the hinge pin (1);
– place a spacer (2) under the door to keep it in place;
– line the lower bracket (4) up with the holes on the appliance and secure it with the screws (3);
– remove the spacer;
2
3
4
1
Fig. 13
– check the correct opening and closing of the door, making sure that, when closed, the sealing gasket correctly
adheres to the surfaces of the appliance;
– also check that the door stays open if opened more than 90° and that the return spring closes it when the opening
angle is less than 90°.
2.9 Reversing the double door opening
The default opening direction of the appliance is to the “right” (opening from right to left). If it is necessary to reverse
the opening direction of the door, proceed as follows:
– take the upper right hinge (1);
– make sure there are no food products inside the appliance. Empty it, if necessary;
– disconnect the appliance from the electrical power supply;
– remove the front upper door control panel, taking care to disconnect the electrical connector for the digital con-
troller and, if necessary, for the door micro-switch;
STANDARD
1
Fig. 14