Name: Beta REV 3
Brand: Beta
Rating: 5 (1 reviews)

To Next Page

To Previous Page

MAINTENANCE AND CHECKS

FRONT BRAKEFRONT BRAKE

FRONT BRAKE

CheckCheck

Check

To check the front brake for wear, simply

observe the caliper from the front, where

it is possible to see the ends of the two

pads. These pads should have at Ieast a

2 mm Iayer of Iining. If this layer is thinner

than 2 mm, replace the pads immediately.

Note:Note:

Note:

Observe the times given on the chart on

pag. 62 when performing the check.

ReplacementReplacement

Replacement

To replace the pads, proceed as follows:

•Disassemble the disk cover and the

caliper by unscrewing the two screws

and releasing the screw

•Slide the split pin

•Unscrew the screw

•Remove the pads

D D

D and replace them

•To reassemble, proceed in the reverse

order.

Note:Note:

Note:

To avoid braking problems, pay particular

attention to the correct reassembly of the

split pins.

If the brake disk is removed, applyIf the brake disk is removed, apply

If the brake disk is removed, apply

Loctite to the screws whenLoctite to the screws when

Loctite to the screws when

reassembling.reassembling.

reassembling.

Questions and Answers:

Need help?

Do you have a question about the Beta REV 3 and is the answer not in the manual?

Beta REV 3 Specifications

General