EasyManua.ls Logo

Beta RR 480 EFI - Clutch Control; Check the Level

Beta RR 480 EFI
82 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
CHECKS AND MAINTENANCE
54
GB
2
1
CLUTCH CONTROL
CHECK THE LEVEL
To check the oil level in the clutch pump,
first remove cover 2.
Remove the two screws 1 and take off
cover 2 together with the rubber bellows.
With the clutch pump in a horizontal posi-
tion, the level of the oil should be 5 mm
below the upper rim.
In the case where the level is lower than
specified top up.
Use the liquid indicated on page 14 in
the “Recommended lubricants and liquids”
table.
WARNING:
The clutch fluid is extremely corro-
sive. Take care not to spill it on the
paintwork.
Wear appropriate protective cloth-
ing and protection gloves.
Keep coolant out of reach of chil-
dren.
WARNING: Avoid any direct con-
tact of the liquid with skin, eyes or
clothing. If this happens:
- with the eyes, rinse immediately with
plenty of water and seek medical advice.
- with skin, immediately clean contaminat-
ed areas with soap and water. Change
clothing that is contaminated with liquid.
If liquid is swallowed, contact a doctor
immediately.

Table of Contents

Related product manuals