Bewator Bewacom BM3 - Setting a password; Setting Bewacom to programming mode

14 Bewacom Technical manual
Setting a password
The first thing to do is to set a password. You
will later use the password each time you want
to programme the Bewacom.
1 Open the Bewacom and turn it around so
the circuit board can be seen.
2 Press the SW1 button (see the wiring
diagram on page 10). zz
3 Enter the desired 6-digit password. 
4 Make a note of the password and store
the note in a safe place.
Setting Bewacom to programming
mode
To programme a function, set Bewacom to
programming mode.
1 Press and hold the B button on the
Bewacom keypad until the beeper goes
off an the yellow LED goes out (approx
3 seconds).
2 Enter the 6-digit password. zz