16 Bewacom Technical manual
Changing entrance codes
1 Set Bewacom to programming mode.
2 Enter the access code to change.
3 Enter the new access code.
4 Enter the new access code again.
5 To only change the code – without
changing the time control group – press
B now.
If the code is not timed, press 0.
If the is timed, select the desired
input (see below).
1 = the code can be timed from a
time clock connected to input 1.
2 = the code can be timed from a
time clock connected to input 2.
Also see the wiring diagram on
page 10.
6 Follow steps 2-5 to change the next code.
7 Press B to exit programming.
To Next Page
Loading...
