Bewacom Technical manual 15
Programming access codes
(first time)
Four different 4-digit entrance codes can be
programmed.
1 Set Bewacom to programming mode.
2 Press 0000.
3 Enter the desired access code using
4 digits.
4 Enter the code once again.
5 If the code is not to be time controlled,
press 0.
If the code is to be time controlled,
select the desired input (see below).
1 = the code can be timed from a
time clock connected to input 1.
2 = the code can be timed from a
time clock connected to input 2.
Also see the wiring diagram on
page 10.
6 Follow steps 2-5 to programme the next
code.
7 Press B to exit programming.
To Next Page
Loading...
