Bewacom Technical manual 7
Limitations
Bewacom cannot normally call extensions
beginning with 0 or extensions consisting of
more than 4 digits. If the installation requires
alterations in these limits, contact Bewator.
Requirements for connecting
Bewacom to a telephone system
An analogue extension (two wires) must be
used for the connection of Bewacom. The
telephones to be called by Bewacom must be
able to send a standard tone signal to
Bewacom for the door release function to
work.
How to test whether the telephone system
meets the requirements or not:
1 Connect an ordinary push button
telephone to the Bewacom extension, and
dial any of the other extensions on the
telephone system.
2 Ask the person answering at the other
end to press the 5 key on the telephone
keypad. If a tone is heard, Bewacom
should work correctly.
To Next Page
Loading...
