Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail: bibo@ourbibo.com
can cut some from that spool to have a roll of filament ). One runs clockwise and
the other one runs counter – clockwise. For not rolled on spool test filament, is the
same operation.
Sharp the filament head with scissor and let the filament be as straight as you
can to ensure it come to the hole of extruder smoothly. If it is difficult to put the
filament to the hole of nozzle on the way, please rotate the filament in different
direction and try more times.
The loading filament video is here:
https://drive.google.com/file/d/18hwVbFtGzk53abkJP-N7KkdXEnYZVg6_/view?u
sp=sharing
Load the filament to the filament guide tube for two extruders (if only loading
for one extruder, the printing will be paused or beeping) as the photo below:
When the extruders reach 220℃, please push the filament down to the extruder
about 90mm (3.54 inches ) deep by hand. If the extruder has the lever, please
To Next Page
Loading...