Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail:
bibo@ourbibo.com
The MONITOR menu in cura may show the status of the printing, but the
information has the time delay. So usually we don’t use this menu, and just
look at the touch screen directly. When you stop (Abort) the printing, the printer
may execute the last gcode command before stopping. So if the printer is
heating the bed or extruder when you stop the printing, the heating will be still
continued (seems not responding your printing stop command). If you want the
printer be responsive, you can restart the printer.
Wifi in client mode (BIBO 3d printer can connect your wifi router)
In client mode, the operation is almost the same as AP mode. But there are
two difference as below:
To Next Page
Loading...