Shaoxing Bibo Automatic Equipment Co., Ltd.
Tel:+86 575 88918283 Mobile:+86 133 25759139
Url: www.ourbibo.com E-Mail:
bibo@ourbibo.com
A. In mks_config.txt file, revise the "cfg_wifi_mode" to be
0 , >cfg_wifi_ap_name:bibo to be your wifi name (your wifi name to replace
216). Also revise >cfg_wifi_key_code:jinjinkeji to be your own wifi
password(your wifi password to replace jinjinkeji). Now save the file and copy it
to the SD card and insert the SD card to the printer. Power on the printer(this
step is very important, should insert the SD card first then power on the printer),
and after a short while of touch screen booting, the wifi configuration will be
valid(there will be a file named config_cur in SD card).
(If you want fixed ip for wifi unit, please kindly revise the >cfg_ip_dhcp_flag:1
to be >cfg_ip_dhcp_flag:0 in mks_config.txt , also type your gate, mask and ip
address you want, then save it.)
B. There is no need to let your PC to connect the wifi of BIBO 3D printer, just
let your PC or smart phone connect the wifi which is BIBO 3D printer also
connected.
***Solution in Client (STA) mode***
The WLAN access point / router cannot be connected.
Check the following points.
-Unplug the power to your wireless access point / router, wait for 1 0 seconds,
then plug it back in.
-If your WLAN access point / router is using MAC address filtering, please
disable the MAC address filtering first.
-Check how many devices are connected with your WLAN router.Usually one
normal router can only be connected with 15 devices.If it is fully connected, no
new devices can be connected.
-Printer's wifi module is not strong to receive the wifi signal as other normal
wifi devices. Please ensure the wifi signal is good near the printer.
-This device does not support a 5GHz SSID / ESSID and you must select a
2.4 GHz SSID / ESSID. Make sure the access point / router is set to 2.4 GHz
or 2.4GHz/5 GHz mixed mode.
-If you manually entered the SSID and security information (SSID /
authentication method / encryption method / Network Key) the information may
be incorrect.
-Reconfirm the SSID and security information and reenter the correct
information as necessary.
-In SD card configuration way, we copy mks_config.txt file directly (not folder)
to the sd card and then insert the sd card to the printer which is powered off.
Then power on the printer, and usually wait for about 2 or 3 minutes, the printer
will connect your room's wifi .
-Change another computer or mobile phone to connect with the printer by wifi.
Some computers or mobile phones may have the problem to communicate
with the printer by wifi.
To Next Page
Loading...