Versie: 5.0 (04-06-2012) 41
6 . . Faults
6.1 Safety instructions
Danger:
d Work on the unit’s interior may be performed
only by appropriately qualified technical staff.
Warning:
w Before you begin: read the safety instructions.
See also:
1.4 Safety instructions 10
6.2 Checking for faults
Note:
n You do not need to be an expert to carry out the
following checks.
If you suspect a fault, carry out the following to determine
whether there is a fault:
1. Carry out the following steps to determine whether the
phenomenon can be easily remedied or whether it is
caused by a fault.
2. If you determine that there is a fault that cannot be reme-
died by the following steps, please contact your supplier.
6.2.1 For CYQ:
1. Set the system to heating mode with the Daikin control
panel and set the temperature to Maximum.
- If the unit does not discharge air or warm air after 15
minutes, then there is a fault.
2. Set the temperature to Minimum.
- If the unit still discharges warm air after 15 minutes,
then there is a fault.
To Next Page
