2 Safety BigRep STUDIO
56
2.5. Operating Environment / Requirements
The BigRep STUDIO can’t be used at heights above 2000 meters above sea level.
Make sure the ground is leveled and
has suicient load-bearing capacity.
Make sure there is enough free space
between the machine and the ceil-
ing (at least 1 m to the device).
Make sure that there is a free zone of
at least 1m to all sides o to the de-
vice (Fig. 2-2).
Take particular care to ensure that there is enough free space behind the control
cabinet (T) at the back of the printer. (See Fig. 3-1 following page)
Once printing has started, the device may not be made accessible to any unautho-
rized persons!
& Chap 2.3 Operator Obligations
For a satisfactory printing process, make sure to:
› Avoid high humidity
› Keep the temperature in the operating environment between +15° and +35° C
› Avoid strong dras during the printing process
› Avoid direct exposure of the device to sunlight
› Not operate the device on surfaces particularly sensitive to vibrations
› Avoid serious indoor air pollution with dust (e.g. sanding dust)
› Avoid inadequately adjusted lighting levels
2.6. Limits Of Use
The printer is not appropriate for
› Heating food
› Printing food
› Illumination of rooms
Fig. 2-2: Free zone
To Next Page
Loading...
