Shenzhen Big Tree Technology Co., Ltd.
BIGTREETECH
7 / 39
13. Three-way four-wire fan interface is reserved, and can be used to connect the
water cooling device;
14. The proximity switch interface is reserved, supports NPN and PNP types,
(24V, 12V, 5V) voltage selection is available, common voltage selection with
VFAN6;
15. Provide the SPI expansion interface to allow Klipper firmware users to
connect an external acceleration sensor for acceleration compensation.
1.2 Basic Parameters
1. Product Size: 170 x 102.7mm, you can read more details here
BIGTREETECH MANTA M8P V1.0-SIZE-top.pdf
2. Installation Size: Please read: BIGTREETECH MANTA M8P V1.0-SIZE-
top.pdf
3. Microprocessor: ARM Cortex-M0+ STM32G0B1VET6 64MHz
4. Drive Input Voltage: VIN（12V/24V） Or HV(≤56V)
5. Motherboard Input Voltage: VIN=DC12V or DC24V
6. Heated Bed Input Voltage: BED IN=DC12V or DC24V
7. Logic Voltage: DC3.3V
8. Heating Port: Heated Bed(HB), Heater Cartridge(HE0, HE1, HE2, HE3)
9. The maximum output current of the heated bed port: 10A, Peak Value: 12A
10. The maximum output current of the heater cartridge port: 5.5A, Peak Value:
6A
11. Fan Port: Two-wire CNC Fan (FAN0, FAN1, FAN2, FAN3), four-wire CNC Fan
fan (FAN4, FAN5, FAN6), Always-on Fan (24V FAN x 2), among which the
CNC Fan voltages are 5V, 12V, 24V optional
12. The maximum output current of the fan port: 1A, Peak Value: 1.5A
13. Total current for heater cartridge + driver + fan: ＜12A
14. Extended Interface: BLTouch(Servos, Probe), PS-ON, Fil-DET, RGBx2, SPI
15. Motor Driver: Support TMC5160, TMC2209, TMC2225, TMC2226, TMC2208,
TMC2130, ST820, LV8729, DRV8825, A4988...
16. Driver Working Mode Support: SPI, UART, STEP/DIR
To Next Page
Loading...
Need help?
General
