Binatone iDECT L1i System - Clock & Alarm; Date & Time; Change Date Format; Change Time Format

19
CLOCK & ALARM
7
If you subscribe to the Caller Display service, the time and date settings
will be automatically updated by the network when you receive a call.
The Caller Display service only sends the month and date, not the year, so
you may need to set the year.
7.1 Date & Time
7.1.1 Change date format
In Idle:
1. Press [ Menu ] and <UP/DOWN> to scroll to Clock/Alarm.
2. Press [ Select ] to show Date & Time.
3. Press [ Select ] to show Date Format.
4. Press [ Select ] and <UP/DOWN> to scroll to your desired date format
of either DD-MM-YYYY or MM-DD-YYYY.
5. Press [ Select ] to confirm.
7.1.2 Change time format
In Idle mode:
1. Follow steps 1 to 2 in Section 7.1.1.
2. Press [ Select ] and <UP/DOWN> to scroll to Time Format.
3. Press [ Select ] and <UP/DOWN> to scroll to your desired time format
of either 12 Hours or 24 Hours.
4. Press [ Select ] to confirm.
7.1.3 Set the date
In Idle mode:
1. Follow steps 1 to 2 in Section 7.1.1.
2. Press [ Select ] and <UP/DOWN> to scroll to Set Date.
3. Press [ Select ] and enter the date according to the date format you set
in Section 7.1.1.
4. Press [ OK ] to confirm and save the new date.
Note: If an invalid date is detected, an error tone will sound and the date
will not be accepted.