Binder FDL 115 - Certificate for the GS Mark of Conformity of the Deutsche Gesetzliche Unfallversicherung E.V. (German Social Accident Insurance (DGUV)

75 pages

Save Page as PDF

To Next Page

To Previous Page

FDL (E2.1) 05/2016 page 67/75

18.2 Certificate for the GS mark of conformity of the “Deutsche Gesetzliche Un-

fallversicherung e.V.” (German Social Accident Insurance (DGUV)

Main Page

Default Chapter2
- Table of Contents2
1 Safety4
- Legal Considerations4
- Structure of the Safety Instructions4
- Localization / Position of Safety Labels on the Chamber6
- Type Plate7
- General Safety Instructions on Installing and Operating the Chambers8
- Intended Use9
- Operating Instructions9
- Measures to Prevent Accidents10
- Important Points to Consider before Commissioning12
2 Chamber Description13
- Chamber Overview14
- Control Panel15
- Solvent Curve FDL 11515
3 Completeness of Delivery, Transportation, Storage, and Installation16
- Unpacking, and Checking Equipment and Completeness of Delivery16
- Guidelines for Safe Lifting and Transportation17
- Storage17
- Location of Installation and Ambient Conditions17
4 Installation of the Equipment18
- Operating Instructions18
- Electrical Connection19
- Connection to a Suction Plant (Optional)19
5 Start up20
- Settings at the RD3 Program Controller20
- General Indications22
6 Fixed Value Entry Mode23
7 Week Program Editor24
- Program Table Template for Week Program Editor26
8 Program Editor27
- Selecting between Set-Point Ramp and Set-Point Step27
- Set-Point Entry for Program Operation30
- Program Table Template33
- Deleting a Program Section34
9 Program Start Level35
10 User Level37
11 Behavior in Case of Failures44
- Behavior after a Power Failure44
- Alarm Messages44
12 Safety Devices44
- Temperature Safety Device Class 244
- Exhaust Air Monitoring46
13 Options47
- Communication Software APT-COM™ 3 Datacontrolsystem (Option)47
- Ethernet Interface (Available Via BINDER INDIVIDUAL Customized Solutions)47
- Coil-Coating Door Flap (Option)47
- Additional Measuring Channel for Digital Object Temperature Indicator with Pincer-Type Sensor (Option)48
14 Maintenance, Cleaning, and Service49
- Maintenance Intervals, Service49
- Cleaning and Replacing the Intake Filter50
- Cleaning and Decontaminating the Safety Drying Oven50
- Cleaning50
- Decontamination52
- Sending the Chamber Back to BINDER Gmbh53
15 Disposal53
- Disposal of the Transport Packing53
- Decommissioning54
- Disposal of the Chamber in the Federal Republic of Germany54
- Disposal of the Chamber in the Member States of the EC Except for the Federal Republic of Germany55
- Disposal of the Chamber in Non-Member States of the EC56
16 Troubleshooting57
17 Technical Description59
- Factory Calibration and Adjustment59
- Definition of Usable Volume59
- Technical Data FDL 11559
- Equipment and Options (Extract)62
- Accessories and Spare Parts (Extract)63
- Dimensions FDL 11564
18 Certificates and Declarations of Conformity65
- EU Declaration of Conformity65
  - Certificate for the GS Mark of Conformity of the "Deutsche Gesetzliche Unfallversicherung E.V." (German Social Accident Insurance (DGUV)67
19 Product Registration69
20 Contamination Clearance Certificate70
- For Chambers Located Outside USA and Canada70
- For Chambers in USA and Canada73

Binder FDL 115 - Certificate for the GS Mark of Conformity of the Deutsche Gesetzliche Unfallversicherung E.V. (German Social Accident Insurance (DGUV)

Table of Contents

Related product manuals