Binder KB 115 (E4) - 14.4 Confirming a Set Alarm

KB (E4 + E6) 02/2017 page 95/148
14.4 Confirming a “set” alarm
Fixed value
08.03.2015 15:05:02
Initial view with overtemperature safety controller
alarm.
The buzzer sounds (if not deactivated previously).
Press the “Info” button.
Setpoint
Actual value
Temperature [°C]
25.0
29.8
Fan [%]
100.0
User
Info
Menu
Alarm acknowledgement
08.03.2015 05:05:06
Submenu “Alarms” for alarm acknowledgement.
..\ Home/Alarms
Safety controller overtemperature
Close Reset Home
The initial view is displayed. The alarm is still active, therefore the alarm icon continues to be shown. The
buzzer is off.
If there is another active alarm, you can press the “Info” button again and also confirm the alarm with the
“Reset” button.
The following alarm messages may appear in the “Alarm list”: