4. Access to Program Menu
Note: If in the Program Menu no key is pressed for 1 minute, the display is reset without validation of the current
settings.
• Press simultaneously and for 5 seconds: "Program Menu" is displayed
• Release and : "Language / English" is displayed
a.) Language selection
• If you want to choose another language, press : "English" flashes
• Use or to choose another language and press to validate it
b.) Redox measurement menu
• With the keys or , select "Rx measure"
• Press to enter the menu
• Once the settings of this menu are done, press to return to "Program Menu"
b-1. Rx Setpoint setting
❖ With the keys or , select "Setpoint", the current value is displayed on the side (by default:
720mV)
❖ Press again: the value flashes and can be modified
❖ With the keys or , set the desired new value and then press to validate
b-2. Sp type setting (Dosing)
❖ With the keys or , select "Sp Type", the current value is displayed on the side (by default: Low)
❖ Press again: the value flashes and can be modified
❖ With the keys or , set the desired new value and then press to validate
b-3. OFA time setting (Over Feeding Alarm = overdose alarm)
❖ With the keys or , select "OFA time", the current value is displayed on the side (by default: OFF)
❖ Press again: the value flashes and can be modified
❖ With the keys or , set the desired new value and then press to validate
b-4. ALR band setting
❖ With the keys or , select "ALR band", the current value is displayed on the side (by default:
100mV)
❖ Press again: the value flashes and can be modified
❖ With the keys or , set the desired new value and then press to validate
To Next Page
