biochrom Anthos Fluido 2 - Wash Mode Selection; Shaking Time Entry

Biochrom Anthos Fluido-2 Microplate Washer v2.0 Page 50
 Function keys:
<F1> or <F2>
Select "Esc" to return to the main menu without saving any changes or
"<<" to return to the previous screen.
<+> or <->
Use these keys to change the power (pressure) of the liquid for
dispensing (“Low”, “Medium”, “High”).
<enter>
Confirm the selection of the dispensing power and go to the next
screen.
Screen
49.
Wash Mode Selection
Two different wash modes are available:
Bottom: the needles of the manifold are placed into the well (to the
defined position for the used plate) during the wash procedure. This
means that basically only the bottom of the well is washed.
Overflow: the needles of the manifold are placed to a certain position
above the well (to be also defined in the "Define Plate Menu").
Therefore the whole well is thoroughly washed as the wash solution is
only aspirated after it fills the well up to the defined position and
reaches the aspiration needles of the manifold.
 Function keys:
<F1> or <F2>
Select "Esc" to return to the main menu without saving any changes or
"<<" to return to the previous screen.
<+> or <->
Use these keys to toggle between "Bottom" and "Overflow".
Screen
50.
Shaking Time Entry
Wash mode:
<< Esc Overflow
Shaking time:
<< Esc 5 sec