Biodom C15 | instructions for use, maintenance and installation | February 2019
12
WARNINGS
ATTENTION
DISCARD ALL PACKAGING OUT OF REACH OF CHILDREN. DANGER OF SUFFOCATION WITH BAG, FOIL,
POLYSTYRENE ETC.
ATTENTION
Smoke gas discharge MUST NOT BE CONNECTED TO:
• Flue pipe, used by other combustion devices (boilers, stoves, fireplaces etc.);
• Air extraction systems (hoods, air extraction fans etc.).
ATTENTION
Installation of draught closing valves is prohibited!
Flue connection Ø 80 mm from pellet boiler to flue pipe should be:
no more than 12 m long (in case of longer connection, dimension of connection pipe must increase to
Ø 130 mm);
each 90° joint requires a 1 m shorter flue connection;
each joint must be fitted with doors for cleaning;
connections between pipes must be sealed
ATTENTION
If there is too much resistance in extraction system (many joints, improper end fitting, bottlenecks
etc.), extraction of smoke gases is not provided for. Therefore, connection pipes and joints must be
increased to a greater dimension – Ø 130 mm. If the flue does not ensure appropriate extraction of
smoke gases, it can also come do improper operation and, consequently, to alarm from boiler
BIODOM. It is advisable that the flue is inspected by an expert before installing boiler BIODOM.
ATTENTION
Never turn off the boiler by pulling the electrical cable from the socket, while fire is still burning in the
boiler. This could damage the boiler and seriously jeopardize its functioning
To Next Page
Loading...
