Biodom C15 | instructions for use, maintenance and installation | February 2019
33
Figure 12: Cleaning the turbulators
Smoke exhaust fan area should be checked and cleaned every six months.
Make sure the stove and the ash are cool.
Cleaning the interior flue exhaust is done by first removing the cover on the bottom of the box for the
ashes and inserting the vacuum cleaner hose through that hole, as to vacuum out the remaining ashes.
The manufacturer shall in no way be held responsible for damages caused by third parties.
The combustion chamber must be cleaned after each used pellet container, vacuumed and/or
emptied of all impurities remaining after the pellets have burned.
Never put pellets which have not burned back in the pellet container or ash box.
9.2. CONTROL AND PARTS REQUIRING MAINTENANCE
CHECK THE FOLLOWING ITEM AND MAKE SURE THAT THE PELLET BOILER IS OPERATING PROPERLY. THIS
WILL INCREASE ITS EFFICIENCY AND THE EMITTED HEAT INTO THE SYSTEM WILL ALSO INCREASE:
Ensure that the pellet boiler and ashes in it are cool!
• For perfect cleaning, vacuum ashes from beneath the combustion container and from
combustion chamber every week or at each 45 kg pellet container used (whichever comes
sooner). Use a broom or a brush to clean firebox walls.
• Clean the fan for extraction of smoke gases by removing fan protection and cleaning fan blades
with a broom or a brush.
To Next Page
Loading...
