BionX RIDE+ - Page 34

10-20 mm
EN-31
ENGLISH
maIntenanCe
6. Tightenthewheelnutsequallyandevenlytoatorqueof40Nm.Otherwisethesystemmightnot
work properly. If you do not have access to a torque wrench, you can use a normal wrench, but ask
your dealer to check the tightening torque of the nuts at the earliest opportunity.
7. Reconnectthefrontbrake.
Rollerbrake bikes: make sure that the bolt for the brake
arm is securely tightened.
8. Checkifthefrontbrakeworks.
9. Reconnectthemotorconnectors.
10.Putthebatterypackbackontothebike.
11. Activatethesystem.
12.Performashorttestridetomakesurethatthesystemworks.
WARNING. Switch the system Off before you disconnect or connect the connectors of the motor.
You may experience strong sparking and possibly electric shock if you fail to do so.
• Removal/refitting of the rear wheel
Nospecificinstructionsarevalidtoremovetherearwheel.
When refitting the rear wheel:
1. Ensure to align the axle with the frame.
NOTICE. On bikes without a derailleur, the chain may not be adjusted too
tight (measured at the most tight point in the chain), else the RIDE+
system does not work properly and can the rider lose control of the bike
while riding. Adjust the chain so that there is 10-20 mm of slackness in
the chain at its tightest spot when a force of about 100 g is applied.
2. Tightenthewheelnutsequallyandevenlytoatorqueof40Nm.Otherwisethesystemmight
not work properly. If you do not have access to a torque wrench, you can use a normal wrench,
but have your dealer checked the tightening torque of the nuts at the earliest opportunity.
3. Afterwards,performashorttestridetomakesurethatthesystemworks.