9
8
210 1
7
6
3
5
4
11
EN-18
ENGLISH
InstruCtIons for use
4.2 RIDE+ Pro controller
1•Speedindication2•Batterychargelevel3•‘+’button4•Distance,Odometer,Chronometer,
Averagespeed,Clock5•‘-’button6•Currentassistancelevel7•Currentgenerationlevel
8•Mode-switch
button9•On/Off
button10•Lightindicator,OnorOff11•Service
Indication*.
*WARNING. If the Service Indication (a steady or blinking wrench symbol) is visible on the display, refer
immediately to paragraph 7.1 for instructions.
• Switching system On/Off
Press any of the two top buttons briefly to switch the system On.
The battery pack will beep four times, the system will perform a
shortself-check(shownonthedisplayasacountdowninthe
‘speed’-field),andthesystemwillactivate(switchto‘On’).
Assoonasthesystemis‘On’,thescreenwilldisplayandeach
function will be shown next to its corresponding button.
To switch the system Off, press the
button . The battery pack
willbeepfivetimes.Ridingwiththesystem‘On’inlevel0isthe
same as riding with the system ‘Off’. If the bike is left with the
systemon,itwillautomaticallyswitchOffafterabout10minutes.
• Changing the position of the buttons
Normally,theOn/Offbutton andthemode-switch
button
areontheright,andthe‘+’and‘-’buttonsontheleft.
Thefunctionalityofthebuttonscanbeswappedright-to-left.
The code to access this is 2009.Moreinformationabout
programming via the controller can be found later in this manual.
• Assistance
When the motor provides power, the bicycle is in assistance mode. There are four levels of
assistance. The level of assistance is shown by the arrows at the bottom of the display.
WARNING. It is strongly advised to ride away in a straight line when an assistance level is
selected. Never select assistance level 3 or 4 during maneuvering or riding away in a tight corner.
The powerful reaction of motor might take you unawares.
To increase assistance, press button ‘+’. For assistance level 1,
press once. Press again for more assistance. For less assistance
pressbutton‘-’.Whenthereisnoassistancelevelshown,thereis
no assistance so riding is the same as pedaling a normal bicycle.