Mainboard Features
16
4-7. Clear CMOS Jumper: JCMOS1
JCMOS1 Assignment
1 3
1-2 Closed
Normal Operation (default)
1 3
2-3 Closed
Clear CMOS Data
※ Clear CMOS Procedures:
1. Remove AC power line.
2. Make JCMOS1 (2-3) closed.
3. Wait for five seconds.
4. Make JCMOS1 (1-2) closed.
5. Let AC power on.
6. Reset your desired password or clear the CMOS data.
4-8. CNR Codec Primary/Secondary
Selection: JCODECSEL
Pin No. Assignment
1-2
On-board Primary Codec
2-3 CNR Primary Codec
The following procedures are for resetting
the BIOS password. It is important to
follow these instructions closely.
To Next Page
