CB-100-238
Router
BEST
Software
RJ45
RJ45
BEST
Software
BEST
Software
RJ45
Router
RJ45
1)
2)
3)
Fig.26: Plug the network cable into the RJ45 slot at the VARIPACK and unplug it again
Establish communication with the BEST SOFTWARE.
see chapter Commissioning of the VARIPACK fre-
quency inverter, page 39.
7.2 Removable control panel (with display and
keypad)
The VARIPACK frequency inverter can be configured
and monitored completely via the optional removable
control panel (with display and keypad). To do so, in-
sert the SD card delivered with the control panel into
the SD card slot. Afterwards, plug the control panel
either directly in the front panel (instead of the cover)
(see figure 7, page 12) or mount it on the outside of the
switch cabinet or on the switch cabinet door using the
kit for external mounting.
Information
The initial configuration of the VARIPACK fre-
quency inverter for screw compressors and
scroll compressors via the control panel will be
available shortly!
Fig.27: Front and rear view of the control panel with fixing holes and
recess on the back (for external mounting to the switch cabinet)
7.2.1 Kit for external mounting of the control panel
The kit for external mounting of the optional control
panel (part number 34797101) consists of:
• Connecting cable (3m long)
• 4 mounting screws.
Mounting (see figure 27, page 38):
• Mount the control panel on a flat surface, for ex-
ample on the outside of the switch cabinet door.
• Take the openings in the switch cabinet door for the
connections on the back of the control panel into ac-
count (see figure 27, page 38)!
To Next Page
Loading...
Need help?
General
