SRP-350plusIII/352plusIII
Ver. 2.00
3-5 Mounting Partition (Option)
• When using 58mm roll paper, mount the partition in the direction of the arrow as
shown below. When installing the partition, align it with the top and bottom grooves
and tighten the screws to secure it.
- After using 58mm paper, do not change it to a larger paper.
This causes bad print quality.
- Take care not to cut your finger on the surroundings of the part
when installing the partition.
For 80mm users, contact the supplier and install a 58mm partition.
To Next Page
