BIXOLON SRP-350plusIII - DIP Switch Setting Procedure

SRP-350plusIII/352plusIII
Ver. 2.00
- 32 -
4-4 Order of Change Settings
1) Turn off the printer.
2) Open the DIP switch cover located at the back of the printer.
3) Set the DIP switch number.
4) Close the DIP switch cover after the settings have been completed.
5) Position the printer in front and turn it on.
The printer must be turned off when changing the DIP switch settings.
Failure to turn it off may cause a short circuit and damage the printer.