1-6 Using 83mm Paper
Use of the partition depends on the width of the paper.
1-6-1 Remove the partition as shown in the following picture when using 83 mm paper.
※ NOTE
Partition is installed at the factory for 80 mm paper.
Fig 1 Fig 2
※ CAUTIONS
Do not rotate the partition while removing it from the printer as shown in Fig 1 because
the holder may be damaged. Lift up the partition as shown in Fig 2 to remove it safely.
1-6-2 The rest of the installation process after this step is the same as the procedure
described in 1-5.
1-7 Recommended Papers
- TF50KS-E (Paper Thickness: 65μm): Nippon Paper Industries Co., Ltd.
- PD 160R (Paper Thickness: 75μm): New Oji Paper Mfg. Co., Ltd.
- P350 (Paper Thickness: 62μm): Kansaki Specialty Paper, Inc. (USA)
※ CAUTIONS
Use of papers other than those recommended above may damage TPH or degrade
the printing quality and our company is not responsible for the damage caused by
non-recommended papers. If you have to use other products, we recommend that you
use papers with a similar level of quality to the recommended ones.
To Next Page
Loading...
