2. Self Test
The self-test checks whether the printer has any problems.
If the printer does not function properly, contact your dealer. The self-test checks the
following:
2-1 Make sure paper roll has been installed properly.
2-2 Turn on the power while holding down the FEED button with beep.
The self-test begins.
2-3 The self-test prints the current printer status, which provides the control ROM version
and the DIP switch setting.
2-4 After printing the current printer status, self-test printing will print the following,
and pause (The PAPER LED light blinks).
SELF-TEST PRINTING.
PLEASE PRESS THE FEED BUTTON.
2-5 Press the FEED button to continue printing.
The printer prints a pattern using the built-in character set.
2-6 The self-test automatically ends and cuts the paper after printing the following.
*** COMPLETED ***
2-7 The printer is ready to receive data as soon as it completes the self-test.
To Next Page
Loading...
