Bizerba BRS 38 - Installation; Installation Procedure; Electrical Connection

2.1 Installation
To convey the slicer to the supporting area a
trolley and/or a lifting device is necessary.
(Weight of machine > 25 kg).
Pay attention to the supporting area and
required space (section 1.4)
Recommended height of working table:
approx. 800 mm
Requirements to be met by the supporting
area:
S horizontal and level surface
S stable and non--slippery
S rigid (for the machine weight,
see section 1.4)
INSTALLATION
6.009.98.5.10.02
2.2 Electrical connection
S Compare the voltage of outlet with that on
the specification plate.
S Do not connect the machine in case of
non--conformity. Contact BIZERBA
after--sales service!
S The connector should meet the
country--specific standards (section 7.2)
10
Convey and store the
machine according to
the symbol indicated on
the packaging.