S Set required slice thickness by pressing e.g.
“Reduce slice thickness”
(may also be changed during the cutting
process).
S Press key “Individual slices”.
(light emitting diode flashes)
S Cutting process is stopped, if the
-- sensor at the product clamp signals “End”
-- key “Individual slices” is pressed again
S After finishing the cutting process -- the blade
must now be in the blade guard -- open the
protective cover.
Cutting of product
6.009.98.5.10.02
GENERAL INSTALLATION
OPERATING
ELEMENTS
OPERATION/
SLICING
CLEANING ACCESSORIES
OPERATING
CONDITIONS
BLADE RE-
PLACE-
MENT
23
The protective cover
cannot be opened during
cutting process.
To Next Page
Loading...
