71
23. Program chain is used when you need to link to the next file to
be tested. For example, if you need to link to group 2, press 2. If
you do not need to link to another file, input ⓪ and then press
Enter key to confirm.
Program Chain
NO: 2
24. Save the edited files into the EEPROM. Up to 10 program files
can be saved. For instance, press 1 to save the edited file to
program file 1 and then press Enter to confirm.
Save Program
NO: 1
25. Press Esc key to exit menu.
Run Program
Recall Prog
Edit Program
Exit
To Next Page
Loading...