GPH-CMD VHF Radio Installation and Programming
BK RADIO Page 2-3
2.2.1.1 NAVIGATION
When Programming Mode is entered, programming starts (after password
entry) with the Group Parameters (CH 00) for the currently selected group.
To edit another Channel Group (GRP 01 - 25), press and hold the [#] key at
any CH prompt to get the group selection prompt. Enter the number of the
group to be programmed, or press the [PRI] key to increment to the desired
group. Once the desired group is selected, press [FCN] to access the data.
Press the [FCN] key repeatedly to cycle through the data fields, and then
loop back to the CH 00 entry point.
GROUP PARAMETERS (CH 00) include:
Group Options: 1-12345678 (1-7 = undefined, 8 = group scan list bit)
Group Label
To edit channel data, at the CH 00 prompt enter the number of the channel to
be programmed, or press the [PRI] key to increment to the desired channel.
Press the [FCN] key repeatedly to cycle through the data fields, and then
loop back to the CH entry point.
CHANNEL PARAMETERS (CH 01 - 20) include:
Bandwidth ([#] key at CH prompt toggles Wide/Narrow)
RX Frequency
RX CxCSS
TX Frequency
TX CxCSS
Channel Label
To edit global data (GRP 00), press and hold the [#] key at any CH prompt to
get the group selection prompt. Enter ‘0’ to select global data. Press [FCN]
to access the data. Press the [FCN] key repeatedly to cycle through the data
fields, and then loop back to the GRP 00 entry point.
GLOBAL PARAMETERS (GRP 00) include:
Keypad Programming Password
Global Options 1: Battery Saver, TX on PRI1, PRI1 Lock, Scan List
Lock, Backlight Triggers, Beep Disable
Global Options 2: Busy Channel Mode, ANI/DTMF Mode
ANI ID
TX Time-Out Timer
Scan Delay
Backlight Duration
Priority 1 Channel
Priority 1 Group: (skipped if Channel = OFF or MAIN)
Priority 2 Channel
Priority 2 Group: (skipped if Channel = OFF or MAIN)
1 2 3
4 5 6
7 8 9
0
*
#
CLR
FCN
PRI
ENT
To Next Page
Loading...
Need help?
General
