Installation and Programming GPH-CMD VHF Radio
Page 2-4 BK RADIO
2.2.1.2 GROUP PARAMETERS (CH 00)
Press the [FCN] key at the CH 00 prompt to access group parameters.
2.2.1.2.1 GROUP OPTIONS: 1-12345678
This is a group of eight individual options that can be enabled or
disabled.
When an option is enabled, the corresponding number in the
display will flash. When the option is disabled the number is
steady. If you wish to change the option from enabled to
disabled or vice versa, press the number key corresponding to
that option.
OPTIONS 1 THROUGH 7
Reserved for future options.
OPTION 8: GROUP SCAN LIST
When Option 8 is enabled (flashing) the current group will be
scanned when the radio is operating in Group Scan Mode.
Press the [ENT] key to store the group options settings into
memory and advance to the next field.
Press the [FCN] key to advance to the next field without saving
changes.
2.2.1.2.2 GROUP LABEL
After Group Options, the display will show the label for the
Channel Group. Each Channel Group can have a label of up to
twelve characters or spaces. The characters can include 0-9, A-
Z, –, -, ., *, +, <, >, /, \, |, $, %, h, or blank.
If no change is needed, press the [FCN] key to go back to the
starting point for Channel 0 settings.
NOTE: Special software available from BK Radio lets you
enter Group Labels and Channel Labels from a
computer. Contact your dealer for information.
Changing The Group Label
Labels are edited from left to right. Pressing the [PRI] key
moves the cursor to the next character. Pressing and holding
the [PRI] key backspaces to the previous character.
The number keys 2 – 9 allow for entry of the letters printed on
the respective keys. For example, the first press of the [2] key
enters the letter A, the second press enters a B, the third press
enters a C, and the forth press enters a 2. The letters Q and Z
are entered with keys 7 and 9.
PROG
LABEL 1
GROUP LABEL
PROG
1-12345678
GRP OPTIONS
To Next Page
Loading...
Need help?
General
