CHAPTER 4: ANALOG PORT OPERATION
25
To disconnect the user from a server:
NOTE:
The OSD must initially be off (not displayed) to use this command.
1. Press Print Screen. The Main dialog box appears.
2. Press
Alt+Ø. This leaves the user in a free state, with no server selected. The
status fl ag on your desktop displays Free.
-or-
Click Disconnect in the Main dialog box.
To remove offl ine SAMs from the server list:
Click Clear in the Main dialog box.
Soft switching
Soft switching is the ability to switch servers using a hotkey sequence. You can soft
switch to a server by pressing
Print Screen and then typing the first few characters
of its name or number. If you have set a Screen Delay Time and you press the key
sequences before that time has elapsed, the OSD will not display.
To confi gure servers for soft switching:
1. Press
Print Screen to launch the OSD. The Main dialog box appears.
2. Click Setup - Menu. The Menu dialog box appears.
3. For Screen Delay Time, type the number of seconds of delay desired before the
Main dialog box is displayed after
Print Screen is pressed.
4. Click OK.
To soft switch to a server:
1. To select a server, press
Print Screen. If the display order of your server list is by
port (Port button is depressed), type the port number and press
Enter.
-or-
If the display order of your server list is by name or EID number (Name or EID
button is depressed), type the fi rst few characters of the name of the server or
the EID number to establish it as unique and press
Enter.
2. To switch back to the previous server, press
Print Screen then Backspace.
To Next Page
Loading...
