SERVSELECT IP™ INSTALLER/USER GUIDE
54
7. From the main menu, type 2 to select Firmware Management. The current
version of your fi rmware displays in the Firmware Management screen.
8. From the Firmware Management menu, type
1 to select FLASH Download.
9. Type the IP address of the TFTP server and press
Enter.
10. Type the name of the FLASH fi le and press
Enter.
11. Confi rm the TFTP download by typing
y or yes and pressing Enter.
12. The ServSelect IP will verify the fi le you downloaded is valid. Next you will be
prompted to confi rm the upgrade. Type
y or yes and press Enter.
13. The ServSelect IP will begin the FLASH upgrade process. On-screen indicators
will display the upgrade process. When the upload is complete, the ServSelect
IP will reset and upgrade the internal subsystems.
CAUTION:
Do not cycle power to the ServSelect IP during this process. A loss of power might render the
appliance inoperable and require the unit be returned to the factory for repair. This upgrade may
take up to 10 minutes to complete.
14. Once the upgrade is complete, the startup message from step 4 will appear on
the terminal screen.
7.2 Upgrading the SAM Firmware
You may upgrade SAMs either individually or simultaneously.
To simultaneously upgrade multiple SAMs:
1. If the OSD is not open, press
Print Screen. The Main dialog box will appear.
2. Click Commands - SAM Status. The SAM Status dialog box appears.
Figure 7-1. SAM Status Dialog Box
3. Click one or more types of adaptors to upgrade. Click Upgrade.
To Next Page
Loading...
