SERVSELECT IP™ INSTALLER/USER GUIDE
42
Figure 4-17. Suspect SAMs Dialog Box
4.9 Resetting Your PS/2 Keyboard and Mouse
If your keyboard or mouse locks up during communication with a CPU that has PS/2
type keyboard and mouse ports, you may be able to re-establish operation by issuing a
reset command. The reset command sends a key sequence to the server which causes the
mouse and keyboard settings to be sent to the appliance. With communication re-
established between the server and the appliance, functionality is restored to the user.
NOTE:
This function is for Microsoft Windows-based computers only. Resetting the PS/2 on a computer
running any other operating system may require that you reboot that computer.
To reset the mouse and keyboard values:
1. If the OSD is not open, press
Print Screen. The Main dialog box will appear.
2. Click Commands - Reset PS/2. A message box displays requesting that you
confi rm the reset. Click OK.
a. A message appears indicating that the mouse and keyboard have been reset.
b. Click X to close the message box.
-or-
Click X or press
Escape to exit without sending a reset command to the
PS/2 mouse and keyboard.
4.10 Displaying Version Information
The OSD enables you to display the ServSelect IP and SAM firmware versions. For
optimum performance, keep your firmware current. For more information, see Chapter 7.
To display version information:
1. Press
Print Screen. The Main dialog box will appear.
2. Click Commands - Display Versions. The Version dialog box appears. The top
half of the box lists the subsystem versions in the appliance.
To Next Page
Loading...
