SERVSELECT IP™ INSTALLER/USER GUIDE
36
To immediately turn on the screen saver:
NOTE:
The OSD must initially be off (not displayed) to use this command.
1. Press Print Screen. The Main dialog box appears.
2. Press
Pause to initiate the screen saver.
NOTE:
The screen saver must already be enabled to perform this task.
4.5 Setting the Keyboard Country Code
NOTE:
Using the keyboard code that supports a language different from that of your ServSelect IP
fi rmware will cause incorrect keyboard mapping.
Sun servers may use key mappings for non-US keyboards. By default, ServSelect IP
appliances send the US keyboard country code to Sun and USB modules attached to
servers, and the code is applied to the servers when they are powered up or rebooted.
Codes are then stored in the SAMs.
Issues may arise when you use the US keyboard country code with a keyboard of
another country. For example, the Z key on a US keyboard is in the same location as
the Y key on a German keyboard. Sun servers will interpret pressing the
Y key on a
German keyboard as the
Z key when the US keyboard country code is used.
The Keyboard command enables you to send a different keyboard country code than
the default US setting. The specified country code is sent to all servers attached to
the ServSelect IP appliances when they are powered up or rebooted, and the new
code is stored in the SAMs.
NOTE:
If a SAM is moved to a different server, the keyboard country code will need to
be reset.
See Chapter 8 for information on emulating certain Sun keys using a PS/2 keyboard
and special considerations for Japanese and Korean Sun USB keyboards.
NOTE:
Only local users can view or change keyboard country code settings.
To set the keyboard country code for Sun servers:
1. If the OSD is not activated, press Print Screen. The Main dialog box
will appear.
2. Click Setup - Keyboard. The Keyboard dialog box appears.
To Next Page
Loading...
