CHAPTER 4: ANALOG PORT OPERATION
35
4. Click OK to eliminate your password.
To enable the screen saver mode with no password protection:
1. If your console does not require a password to gain access to the Security
dialog box, proceed to step 2.
-or-
If your console is password protected, see the previous procedure, then go to step 2.
2. From the Main dialog box, click Setup - Security. The Security dialog box
will appear.
3. Select Enable Screen Saver.
4. Type the number of minutes for Inactivity Time (from 1-99) to delay activation
of the screen saver.
5. Choose Energy if your monitor is E
NERGY STAR compliant; otherwise select Screen.
CAUTION:
Monitor damage can result from using Energy mode with monitors not compliant with E
NERGY STAR.
6. (Optional) Click Tes t to activate the screen saver test which lasts 10 seconds
then returns you to the Security dialog box.
7. Click OK.
NOTE:
Activation of the screen saver mode disconnects the user from a server; no server is selected.
The status fl ag displays Free.
To exit the screen saver mode:
Press any key or move your mouse. The Main dialog box appears and any previous
server connection will be restored. If a digital user is on that connection, they will be
disconnected and will receive a preemption message.
To turn off the screen saver:
1. From the Main dialog box, click Setup - Security. The Security dialog
box appears.
2. In the Security dialog box, clear Enable Screen Saver.
3. Click OK.
To Next Page
Loading...
