SERVSELECT IP™ INSTALLER/USER GUIDE
34
To set or change the password:
1. Single-click and press
Enter or double-click in the New text box.
2. Type the new password in the New text box and press
Enter. Passwords must
contain both alpha and numeric characters, are case sensitive and may be up to 12
characters long. Legal characters are: A-Z, a-z, Ø-9, space and hyphen.
3. In the Repeat box, type the password again and press
Enter.
4. Click OK to change your password, and then close the dialog box.
NOTE:
If you should lose or forget your password, you must return your ServSelect IP.
To password protect your console:
1. Set your password as described in the previous procedure.
2. Select Enable Screen Saver.
3. Type the number of minutes for Inactivity Time (from 1-99) to delay activation
of password protection and the screen saver feature.
4. For Mode, select Energy if your monitor is E
NERGY STAR
®
compliant; otherwise
select Screen.
CAUTION:
Monitor damage can result from using Energy mode with monitors not compliant with E
NERGY STAR.
5. (Optional) Click Tes t to activate the screen saver test which lasts 10 seconds
then returns you to the Security dialog box.
6. Click OK.
To log in to your console:
1. Press any key or move the mouse.
2. The Password dialog box appears. Type your password, then click OK.
3. The Main dialog box appears if the password was entered properly.
To remove password protection from your console:
1. From the Main dialog box, click Setup - Security; the Password dialog box
appears. Type your password, then click OK.
2. In the Security dialog box, single-click and press
Enter or double-click in the
New box. Leave the box blank. Press
Enter.
3. Single-click and press
Enter or double-click in the Repeat box. Leave the box
blank. Press
Enter.
To Next Page
Loading...
