SERVSELECT IP™ INSTALLER/USER GUIDE
48
5. Terminal Operations
Each individual ServSelect IP may be configured at the unit level through the
configuration port on the back of the unit. All terminal commands are accessed
through a terminal or PC running terminal emulation software.
5.1 Configuring the Terminal Menu
The ServSelect IP Terminal menu features seven selections: Network Configuration,
Firmware Management, Enable Debug Messages, Set/Change Password, Reset
Factory Defaults, Reset Appliance and Exit.
Figure 5-1. Terminal Menu
To access the Terminal menu:
1. Connect a terminal or PC running terminal emulation software (such as
HyperTerminal) to the confi guration port on the back panel of the ServSelect IP
using a RS232 DB9 null modem cable. The terminal should be set to 9600 bps,
8 data bits, 1 stop bit, no parity and no fl ow control. The terminal may be
connected at any time, even when the ServSelect IP is powered up.
2. Press any key to access the main menu.
To Next Page
Loading...
