SERVSELECT IP™ INSTALLER/USER GUIDE
38
Commands to Manage Routine Tasks for Your Servers
Feature Purposes
Broadcast Enable Begin broadcasting to your servers. Confi gure a server list for
broadcasting under the Setup dialog box.
Scan Enable Begin scanning your servers. Set up a server list for scanning in
the Setup dialog box.
User Status View and disconnect users.
Run Diagnostics Validate the integrity of your system including memory, fi rmware
CRCs, comm interfaces, switch controller, local and remote video
and SAM adaptors.
SAM Status Simultaneously upgrade multiple SAM adaptors.
Reset PS/2 Re-establish operation of PS/2 keyboard and mouse.
Display Versions View version information for the appliance as well as view and
upgrade fi rmware for individual SAM adaptors.
To access the Commands menu:
1. Press
Print Screen to launch the OSD. The Main dialog box appears.
2. Click Commands. The Commands dialog box appears.
Figure 4-13. Commands Dialog Box
4.7 Viewing and Disconnecting User Connections
You can view and disconnect users through the User Status dialog box. The user
name (U) will always be displayed; however, you can display either the server name
or EID number to which a user is connected. If there is no user currently connected
to a channel, the user field will be blank and the server field will display Free.
NOTE:
The local user can be disconnected by a digital user via the ServSelect IP software. See the
ServSelect IP Software Installer/User Guide for additional information.
To Next Page
Loading...
