CHAPTER 4: ANALOG PORT OPERATION
41
To run diagnostic tests:
1. If the OSD is not open, press
Print Screen. The Main dialog box will appear.
2. Click Commands - Run Diagnostics. A warning message appears indicating
that all users will be disconnected.
3. Click OK to begin diagnostics.
-or-
Click X or press
Escape to exit the dialog box without running a diagnostic test.
4. All users are disconnected and the Diagnostics dialog box displays.
Figure 4-16. Diagnostics Dialog Box
5. As each test is fi nished, a pass (green circle) or fail (red x) symbol appears. The
test is complete when the last test’s symbol displays.
6. (Optional) If you have any Offl ine SAM adaptors, you can click the Clear
button to remove them from the list.
7. (Optional) If you have any Suspect SAM adaptors, you can click the Display
button. The Suspect SAMs dialog box appears.
a. Make a note of each SAM adaptor in the list. In Figure 4-17, the fi rst SAM
(Sw-4) is attached to channel 4 of a cascade switch, the second (???) is non-
communicative and the third (Srvr) is attached directly to a server. You may
want to troubleshoot each of these SAM adaptors.
To Next Page
Loading...
