SERVSELECT IP™ INSTALLER/USER GUIDE
60
5. Repeat steps 3 and 4 to confi gure additional macros.
6. When fi nished, press
Enter to return to the previous screen.
Using History mode
History mode allows you to examine the contents of the history buffer, which
contains the events that have occurred.
The serial SAM maintains a buffer containing 240 lines minimum, or 10 screens, of
output. When the history buffer is full, it will add new lines at the bottom of the
buffer and delete the oldest lines at the top of the buffer.
NOTE:
The Confi g Key Sequence, On-Line Key Sequence and Clear History Key Sequence used in the
following procedure are the default values. These key combinations can be changed using the
Confi guration Screen.
To use History mode:
1. Press
Ctrl-F9. The mode will display as History.
2. Press one of the following key combinations to perform the
indicated action:
•
Home - Move to the top of the buffer.
• End - Move to the bottom of the buffer.
• Page Up - Move up one buffer page.
• Page Down - Move down one buffer page.
• Up Arrow - Move up one buffer line.
• Down Arrow - Move down one buffer line.
• Ctrl-F8 - Enters Confi guration mode. The Confi guration Screen will
appear. Press Ctrl-F9 to return to the previous screen with History mode
enabled, or Ctrl-F10 to return to the previous screen with On-Line mode
enabled.
• Ctrl-F11 - Clears the history buffer. If you choose this option, a warn-
ing screen will appear. Press Enter to delete the history buffer, or Esc to
cancel the action. The previous screen will reappear.
3. When fi nished, press
Ctrl-F10 to exit History mode and return to
On-Line mode.
To Next Page
Loading...
