Blaupunkt Brisbane SD48 - Adjusting the volume; Setting the power-on volume; Quickly reducing the volume (MUTE); Cancelling mute

Adjusting the volume
Adjusting the volume
You can adjust the volume in steps from
o (off) to 50 (maximum).
To increase the volume ,
.... turn the volume control ® clockwise.
To decrease the volume,
.... turn the volume control CD counter-
clockwise.
Setting the power-on volume
You can set the power-on volume. You can
adjust it manually or select the "LAST VOL"
setting. If you enable "LAST VOL", the
volume which was set the last time you
switched off the device is re-enabled.
.... Press the MENU button @).
The display shows "MENU".
.... Press the v or 1\ button 0 repeat-
edly until "ON VOLUME" appears on
the display.
.... Press the < button 0 to manually ad-
just the power-on volume and
.... adjust the power-on volume using the
v or 1\ buttons 0.
OR:
.... Press the > button 0 to select the
"LAST VOL" setting.
When you have finished making your
changes,
.... press the MENU button @.
To exit the menu,
.... press the ESC button @.
12 I
Note:
To protect your hearing, the power-
on volume is limited to the value "38"
for the setting "LAST VOL". If the
"LAST VOL" setting is selected and the
volume was set higher than "38" before
switch-off, the value "38" will be used
at switch-on.
Quickly reducing the volume
(MUTE)
You can quickly reduce the volume to a pre-
set level (Mute).
..... Briefly press button 0.
"MUTE" appears on the display.
Cancelling mute
To return to your previously set volume
level,
.... briefly press button 0 again.
Adjusting the mute level
You can adjust the mute level.
..... Press the MENU button@.
The display shows "MENU".
.... Press the v or 1\ button 0 repeat-
edly until "MUTE LVL" appears on the
display.
..... Press the button> 0to open the sub-
menu.
"MUTE" and the currently set value are dis-
played.
.... Adjust the mute level using the button
vor7\0·