Blaupunkt Brisbane SD48 - Switching to MP3 mode; Preparing a USB data carrier; Connect USB data carrier and start MP3 mode

MP3/WMA mode
001
Switching to MP3 mode
® Directories
® Tracks· Files
Preparing a USB data carrier
For the device to recognise a USB data car-
rier,. it must be specified as mass storage
device and formatted using the FAT16 or
FAT32 file system and contain MP3 or WMA
files.
You can create up to 1,000 directories on a
USB data carrier. You can use this device to
access directories individually. The direc-
tory depth is unlimited.
You can store up to 10,000 files in every
directory.
Note
Blaupunkt cannot guarantee the prop-
er functioning of all USB data carriers
available on the market.
002
003
T001
T002
T003
T004
TOOS
T001
T002
T003
T004
TOOS
T006
®
004
T001
T002
T003
T004
TOOS
T006 ®
TOO?
TOOa
T009
T010
T011
Inserting/removing SD/MMC card
.... Insert the SD/MMC card with its la-
belled side to the left and its contacts
first into the card slot ® until it clicks
into place.
You can now select the SD/MMC card as au-
dio source with the SRC button 0.
To remove the SD/MMC card,
.... push on the SD/MMC card until it dis-
engages.
.... Pull the SD/MMC card out of the card
slot0·
Starting MP3 mode of SD/MMC cards
.... Press the SRC button 0 repeatedly
until the display shows "SD CARD".
The playback starts.
Connect USB data carrier and start
MP3mode
To be able to connect a USB data carrier
(e.g. a USB stick or USB hard disk), the
supplied USB cable must be connected to
the rear side of the device as described in
the installation instructions. This cable can
be routed, for example, to the glove com-
partment or a suitable place of the center
console.
Note
Always switch off the device before
connecting or disconnecting the USB
data carrier so that the data carrier is
correctly registered and unregistered.
.... Connect the USB data carrier with the
USB cable.
18 I