Blaupunkt Brisbane SD48 - Display; Adjusting the display brightness; Setting the display illumination colour; Mixing the color for the display illumination (DISP COL)

Display
Display
If you switch on the vehicle illumination,
the display brightness switches day mode
to night mode. This requires that your car
sound system is connected as described in
the installation instructions. Your vehicle
must feature the corresponding connection
option.
Adjusting the display brightness
You can adjust the display brightness
separately for night (DIM NIGHT) and day
(DIM DAY) in steps ranging from 1 to 16.
.... Press the MENU button@.
The display shows "MENU".
.... Press the v or A button 0 repeatedly
until"DIM DAY" or IIDIM NIGHr appears
on the display.
.... Press the > button 0 to call up the
submenu.
II DAY II or IINIGHr and the currently set value
are displayed.
.... Press the v or A button 0 to adjust
the brightness.
When you have finished making your
changes,
.... press the MENU button @.
To exit the menu,
.... press the ESC button @.
30 I
Setting the display illumination
colour
For the display illumination, you can se-
lect a colour from the RGB spectrum (red-
green-blue) or mix using the colours red
and green, select a colour during the col-
our scan or switch on a constant colour
change.
Mixing the color for the display
illumination (DISP COL)
To customise the display illumination to suit
your tastes you can either mix a colour your-
self using the three primary colours red,
green and blue (RGB) or from the colours
red and green (RG).
.... Press the MENU button @.
The display shows "MENU
II
.
....
Press the v or A button 0 repeat-
edy until "DISP COLli appears on the
display.
.... Press the < button 0to open the RGB
menu or the> button 0 to open the
RG menu.
The display shows "4096 COLli for the RGB
menu or 11256 COLli for the RG menu.
.... Press the > button 0 to open the
menu for mixing your own colour.
Either IIR", "G", and 118
11
or IIR
II
and IIG
II
are
displayed with the current values. The set-
ting for IIR
II
is activated. You can adjust a
value from 0 to 16 each for every available
colour component.