Blaupunkt Brisbane SD48 - Sound; Equalizer; Equalizer settings; Adjusting BASS

Sound
Sound
For every source (radio, SO, USB, CD
changer or AUX-IN), you can perform indi-
vidual and separate settings for the sound
(bass, middle and treble) and the equal-
izer.
The X-Bass and volume distribution settings
(balance and fader) apply to all the audio
sources.
Equalizer
This device features a digital 3-band equal-
izer. This equalizer allows for selecting one
frequency each for bass, treble and mid-
dle and to adjust the level for the selected
frequency. In addition, you can adjust the
quality factor for bass and middle.
Equalizer settings
The table below shows the bass, treble and
equaliser setting options in the "AUDIO"
menu.
Some settings feature an II E" (for
"ENHANCED") I e.g. liE-BASSil.
These settings are performed In the
"ENHANCED" submenu.
Note:
The table does not contain all the set-
tings that are possible in the menus
"AUDIO" and "ENHANCED".
Adjusting BASS
To adjust the level of the bass,
.... press the MENU button@.
The display shows "MENU",
.... Press the v or 1\ button 0 repeatedly
untilIAUDIO" appears on the display.
.... Press the> button 0 to call up the
audio menu.
"BASS" appears on the display.
.... Press the> button 0 to call up the
submenu.
Level
(GAIN)
Frequency
(FREQ)
Quality
factor
(QFAC)
-7 to +7
-7 to +7
60 Hz, 80 Hz,
100 Hzor
200 Hz
1.0, 1.25, 1.5
or 2.0
-7 to +7
0.5 kHz,
1.0 kHz. '
1.5 kHz or
2.5 kHz
10 kHz,
12.5 kHz,
15 kHz or
17.5 kHz
0.5, 0.75,1.0
or 1.25
24 I
Basic settings Advanced settings