Blaupunkt Brisbane SD48 - Selecting the colour of the display illumination from the colour scan (COL SCAN); Switching the constant colour change for the display illumination on;off (SCAN)

~ Press the < or > button CD to switch
between the colour components.
~ Press the v or 7\ button CD to adjust
the value of a colour component.
When you have finished making your
changes,
~ press the MENU button@.
To exit the menu,
~ press the ESC button @.
Selecting the colour of the display
illumination from the colour scan
(COL SCAN)
~ Press the MENU button @.
The display shows "MENU".
~ Press the v or 7\ button CD repeat-
edly until "COL SCAN" appears on the
display.
~ Press the> button CD to start the col-
our seek.
The device starts changing the display illu-
mination colour. During the colour scan, the
display intermittently shows "SCANNING"
and "OK (MENU)".
Note:
You can cancel the colour scan by
pressing the v or /\ button CDwithout
adjusting a new display colour.
To select the currently set colour,
~ press the MENU button @.
To exit the menu,
~ press the ESC button @.
Display
Switching the constant colour change
for the display illumination on/off
(SCAN)
You can select a constant colour change as
the colour of the display illumination. If the
colour change is activated, the display col-
our changes constantly. The colour change
is switched on or off in the menu.
~ Press the MENU button @.
The display shows "MENU".
~ Press the v or 7\ button CD repeatedly
until "SCAN ON" or "SCAN OFF" ap-
pears on the display.
~ Press the> button CD to call up the
submenu.
~ Press the > button CD to toggle be-
tween ON (colour change on) or OFF
(colour change off).
When you have finished making your
changes,
~ press the MENU button@.
To exit the menu,
~ press the ESC button @.
I 31