Blaupunkt TravelPilot Rome Europe NAV56E - Setting the Basic Settings of the Navigation System

24
Use the OK button = to change
the response sensitivity of the
HighCut function between "0",
"1" and "2".
"0" means: The HighCut func-
tion is deactivated,
"1" means: The response sen-
sitivity is low.
"2" means: The response sen-
sitivity is high.
Changing the seek tuning
sensitivity
The seek tuning sensitivity deter-
mines whether the automatic sta-
tion seek tuning locates only strong
stations or also weaker stations,
which may be degraded by a high
noise level.
To change the seek tuning sensi-
tivity:
In the settings menu, select and
confi rm the "Tuner" menu item.
The "Tuner" menu appears.
In the "Tuner" menu, select the
"Sensitivity" menu item.
Use the OK button = to select
the seek tuning sensitivity:
A check mark means that the
seek tuning also stops at weak-
er stations,
If no check mark is shown,
the seek tuning stops only at
strong stations.
•
•
•
➜
➜
•
•
Setting the basic settings of
the navigation system
You define the following in the
"Navigation" menu:
Whether the navigation system
announces turn-by-turn direc-
tions (see below),
whether the remaining travel
time or the estimated arrival time
is displayed during destination
guidance (see p. 25),
whether map details are shown
during destination guidance be-
fore you have to make a turn (see
p. 25),
whether TMC traffi c announce-
ments are also announced dur-
ing inactive destination guidance
(see p. 25).
Activating/deactivating voice
output of the navigation system
The navigation system can announce
turn-by-turn directions during des-
tination guidance (see p. 65). This
voice output can be activated or de-
activated as follows:
In the settings menu, select and
confi rm the "Navigation" menu
item.
The menu of the basic settings
of navigation appears.
In the menu of the navigation ba-
sic settings, select the "Speech
output" menu item.
You can activate the speech out-
put (check mark) or deactivate
it (no check mark) with the OK
button =.
•
•
•
•
➜
➜
Tuner
RDS VAR
Alternat. freq.
Regional
Sensitivity
HighCut 0
Tuner
RDS VAR
Alternat. freq.
Regional
Sensitivity
HighCut 0
Basic settings before the trip
ROME56E_eng.indd 24ROME56E_eng.indd 24 23.08.2006 15:04:59 Uhr23.08.2006 15:04:59 Uhr