Blaupunkt TravelPilot Rome Europe NAV56E - Performing a Sensor Test; Calibrating the Device

79
In this case, check the connec-
tion of the antenna.
Performing a sensor test
To check whether the device is cor-
rectly connected:
In the "Installation" menu, select
and confi rm the "Sensor test"
menu item as described under
"Operating the menu" on p. 12.
The sensor data are displayed.
GPS Sat (test of the GPS an-
tenna): If the GPS antenna is
connected, "OK" appears. If the
device receives GPS satellite
signals, their number and fi eld
strength are displayed. The GPS
antenna must be aligned so that
it receives at least 4 satellites
and the fi eld strength is greater
than 40.
Direction (test of the reversing
light signal): If you connected the
reversing signal, "Backward" must
appear if the vehicle is in reverse
gear, and "Forward" if the vehicle
is not in reverse gear.
Ignition (test of the positive igni-
tion connection): If you turn on
the vehicle ignition, "On" must
appear.
Speed signal (test of the speed-
ometer signal): If you connect-
ed the speedometer signal and
move the vehicle a little bit, the
➜
➜
•
•
•
•
speedometer signal pulses must
appear.
Calibrating the device
Before you use the navigation sys-
tem for the fi rst time, you must cali-
brate it.
You can calibrate the naviga-
tion system either automatically
on a longer calibration trip (5 to
15 km) or manually on an exactly
measured distance (100 to 500 m)
(see p. 80).
To calibrate the device:
Switch on the vehicle ignition.
Install the navigation software
(see p. 46).
Keep the navigation CD in the
CD drive.
In the Settings menu, select
and confirm the "Installation"
menu item as described under
"Operating the menu" on p. 12.
The "Installation" menu is dis-
played.
➜
➜
➜
➜
Sensor test
GPS sat: 8 Strength: 41
Direction: Forward
Ignition: On
Speedsignal: 5528
Installation
Speed sig.
Auto calib.
Manual calib.
Antenna test
Sensor test
Installation instructions
ROME56E_eng.indd 79ROME56E_eng.indd 79 23.08.2006 15:05:22 Uhr23.08.2006 15:05:22 Uhr